A 2.00-kg block is pushed against a spring with negligible mass and force constant k= 400 N/m, compressing it 0.220 m. When the block is released , it moves along a friction-less , horizontal surface and then up a friction-less incline with slope 37.0∘37.0^{\circ}37.0∘(Fig).
(a) What is the speed of the block as it slides along the horizontal surface after having left the spring?
(b) How far does the block travel up the incline before starting to slide back down?
Unlock full course notes by signing up
A marble starts from rest and rolls without slipping on the loop-the-loop track in the figure. Find the minimum starting height h from which the ball will remain on the track through the loop. Assume the marble's radius is small compared with R.
A person with mass of 75kg is doing bungee jumping such that he jumps down from rest form the top of a bridge. If the natural length of the bungee cord is 20m and effective spring constant for this bungee cord is 5N/m, what is the speed of the person 20m below the bridge? What is the lowest position of the person respect to the bridge?
A pendulum with length of 0.80m is raised to an angle of 25° below the horizontal and released. What is the velocity of the pendulum as it swings past its lowest point?
A ball of mass M is released from rest at a vertical height h above the ground. The ball rolls down a frictionless inclined plane and makes it to a loop the loop of radius R.
What is the velocity of the ball as it reaches to the bottom of the incline?
What is the normal force at the bottom?
Two balls of equal mass are thrown from the top of a building with height10.0m10.0 m10.0m. One is thrown straight up at 10 m/s10\ m/s10 m/s(call this ball A) and the other is thrown horizontally at 10 m/s10\ m/s10 m/s (call this ball B).
a) Which balls has a greater speed when it reaches the ground? Why? Make sure you include conservation of energy in your answer.
b) Your friend tries to tell you that the ball thrown horizontally would have greater speed, because it has both an x-component and a y-component, and so the speed (magnitude of the velocity) should be higher. Why is he wrong? (Calculation not required, but you can do one if you want.)
A 2 kg2\ kg2 kgball is dropped from a height of 10 m10\ m10 monto the ground.
a) If the balls experiences no losses find the velocity of the ball right before it hits the ground. (in m/s)
b) If the ball loses 25% of its energy when it bounces, what height will it reach on its first bounce? (in m)
Two identical masses are released from rest in a smooth hemispherical bowl of radius R from the positions shown in Fig. You can ignore friction between the masses and the surface of bowl. If they stick together when they collide, how high above the bottom of the bowl will the masses go after colliding in terms of R?
A 0.15 kg frame, when suspended from a coil spring, stretches the spring 0.070 m.A 0.200-kg lump of putty is dropped from rest onto the frame from a height of 30.0 cm(Fig). Find the maximum distance the frame moves downward from its initial position.
A 5 kg chunk of ice is sliding at 12.0 m/s on the floor of an ice-covered valley when it collides with and stick to another 5.00-kg chunk of ice that is initially at rest.(Fig.) Since the valley is icy, there is no friction.After the collision, how high above the valley floor will the combined chunks go?
A 15.0-kg block is attached to a very light horizontal spring of force constant 500 N/m and is resting on a friction-less horizontal table (Fig.). Suddenly it is struck by a 3.00-kg stone traveling horizontally at 8.00 m/s to the right, where upon the stone rebound at 2.00 m/s horizontally to the left.Find the maximum distance that the block will compress the spring after the collision.
Conservation of Energy & Momentum
A 12-g rifle bullet is fired with a speed of 380 m/s into a ballistic pendulum with mass 6.00 kg, suspended from a cord 70.0 cm long. Compute (a) the vertical height through which the pendulum rises , (b) the initial kinetic energy of the bullet, and (c) the kinetic energy of the bullet and pendulum immediately after the bullet becomes embedded in the pendulum.
As shown below, a ball of mass m with an initial velocity 10 m/s collides with an initially stationary ballistic pendulum of mass M=3m, hanging from a string. The two sticks together and system deflects from vertical position to angleΘ=60∘\Theta=60^{^{\circ}}Θ=60∘ What is the length of string?
A compressed spring is used to propel a 25-gram ball-bearing along a horizontal track which contains a circular vertical loop of radius 0.30 m in a vertical plane. The spring obeys Hooke's law and is compressed 20 cm a force of 5 N. What is the speed of the ball-bearing at the top of the loop?
A 1.2-g particle is moving along x-axis under the influence of the following potential energy. The particle turns around at x=6mx=6mx=6m. What is the maximum speed of this particle?
A frictionless roller-coaster track is guiding a car from point A to point D as shown below. The car at
A is at rest and slowly starts its journey. Which set of energy diagrams does correctly represent the
energy at indicated points?
A 12 g bullet moving horizontally at 30 m/s is fired into a vertically suspended pendulum of mass 2.5 kg. The bullet becomes embedded in the pendulum.
A horizontal rod of length L and mass M has a mass m at one end. It is supported by pivot P on the wall at the left end and a cable at angle θ\thetaθ of at the other end as shown.
a) Find the tension in the cable
b) If the cable snaps, with what angular velocity will the rod swing down and slam into the wall?
A box of mass m is pressed against (but is not attached to ) an ideal spring of force constant k and negligible mass, compressing the spring a distance x. After it is released, the box slides up a frictionless incline as shown in the figure and eventually stops. If we repeat this experiment but instead compress the spring a distance of 2x.
A ballistic pendulum is used to measure the speed of a bullet. It consists of a wooden block of mass M = 10kg suspended from a vertical string. A bullet of mass m = 100g strikes and embeds itself in the block and the block swings upward through a vertical distance of 0.10m. What is the bullet's speed?
A car accidentally enters a playing ground at a velocity of 14m/s. A child tosses a ball at the car at 18m/s. What is the ball's speed after it rebounds elastically from the car?
If the coefficient of static friction between the block and the ramp is 0.40.40.4, find the minimum angle such that the block will slide down the slope.
A block with mass m is set to move up an inclined plane.
a) Assume there is no friction, how far will the block slide before come to a stop?
b) Now, assume there is friction between the block and the plane, how far will the block go up the plane?
Minimum sliding angle
If the coefficient of static friction between the block and the ramp is 0.40.40.4, find the minimum angle such that the block will slide down the slope. Give your answer to two sig figs in degrees.
I over-packed a box and it weighs 50kg. I'm pulling it across a rough surface at an angle of 45 degrees above the horizontal with a force of 280N. The coefficient of kinetic friction of the floor is 0.50. I pull for 10 seconds, which causes the box speed up from rest. Then I release it, and it continues to slide, as it slows to a halt.
a) What is its maximum speed?
b) How long until it stops?
Two blocks of mass m and M are connected via pulley with a configuration as shown. The surfaces are frictionless. If M=15 kg and m=8 kg and θ1=30 and θ2=60\theta_1=30\ {\rm and}\ \theta_2=60θ1=30 and θ2=60
Find the acceleration
What is the tension in the string?
A 1.2 kg is at rest on a spring at the base of a 35 degree inclined plane. If the spring constant is 105 N/m, and the spring is compressed by 12 cm, how far will it travel up the incline when it is release?
1) Two masses are attached together by a rope as shown in the picture. If the system is released from the rest, what is the direction of the motion and acceleration for each mass? (Imagine there is no friction between masses and the inclined surface) M2 = 2M1 = 2kg
Forces: Inclined surface
A 40kg wagon attached to a rope is pulled up a hill at an incline of 19° to the horizontal. If the wagon starts from rest and takes 50 seconds to move 92 m up the hill, what is the force of tension in the rope? Find the acceleration of the block.
I'm moving and packed all my books into a box that weighs 17kg. I pull the box on a weightless dolly with a force of 60N at an angle of 30° to the horizontal surface. What is the acceleration of the box?
a) Dave is trying to push a 60kg box up a greased ramp inclined 30°, pushing with a force of 350N. He pushes the box perfectly horizontally, rather than up the ramp, because he’s not terribly bright. What is the box’s acceleration?
b) If Dave forgot his grease at home, the ramp would have μsmax=0.10\mu_{\rm smax}=0.10μsmax=0.10 and μk=0.05.\mu_k=0.05.μk=0.05. He still insists on pushing the box horizontally, with the same force. What would the box’s acceleration be now?
A car travelling at 25 m/s on an uphill with θ = 20° slope runs out of the gas. a) How far up the hill it can move before starting to roll back down?
b) How long does it take for the car to get to the turning point?
A stationary snow/water skier starts to slid down an icy slope inclined 11° until it hits the water. Initially skier is 200 meter away from the surface on the inclined surface. When he hits the water, the skier comes to full stop in 80 meters on the surface of water.
a) What is the acceleration of the skier on the icy slope?
b) How long does it take for the skier to hit the water?
Inclined pully system
Two blocks are connected by a pulley system. One block (10 kg) rests on a plane inclined at 35º to the horizontal, while the other block (9.0 kg) hangs off the edge of the incline. The coefficient of friction between the block and the table is 0.30. The blocks are released from rest, what are their accelerations and what is the tension?
A fixed triangular wedge has two inclined surfaces forming a double inclines plane. Two masses m1 = 5 kg and m2 = 10 kg are attached to a massless pulley connected with an inextensible string. The inclined surface I1 and I2 make an angle α1=60∘\alpha_1=60^\circα1=60∘ and α2=30∘\alpha_2=30^\circα2=30∘ with the horizontal respectively. The coefficient of kinetic friction is μ=0.01.\mu=0.01.μ=0.01. Assume g = 10 m/s2.
a) Draw a free body diagram.
b) Is the system stationary? If not what will be the net acceleration?
A 1400-kg truck ascends a steep road at a speedy 60 km/h, against a 450-N force of air resistance. If the engine supplies energy to the drive wheels at the rate of 38 kW, what is the slope of the road?
Two different boxes of masses m1 = 125kg and m2 = 45kg are sliding down a rough inclined plane angled at θ=35∘\theta = 35^\circθ=35∘ , as seen in the figure. The coefficient of kinetic friction between m1 and the plane is 0.3. The coefficient between m2 and the plane is 0.5. Find the acceleration of the two boxes and the contact force between them.
Practice: Inclined Plane
A box of 10 Kg10\ Kg10 Kg is released from rest at t=0 st=0\ st=0 sfrom the top of a frictionless inclined surface with θ=45°\theta=45\degreeθ=45°. If the box is initially at the top of inclined surface with height of 2 m2\ m2 mrespect to the bottom of the ramp, at what time the box gets to the ground?
Practice: Inclined Plane Theory
Inclined Plane
Sliding down an inclined plane is another example of motion with constant acceleration.
Source of the motion is still gravity of earth but only part of it is affecting the sliding of the object
Forces: Block on slope with friction
A mass of 5 kg5\ kg5 kg is stationary on the surface of an inclined surface with angle of θ\thetaθand coefficient of kinetic friction of 0.30.30.3 and coefficient of static friction of 0.50.50.5. You start increasing the angle of the inclines surface.
Two masses on a pulley on a slope
Two blocks of mass m and M are connected via pulley with a configuration as shown. The surfaces are frictionless. If M=15 kg and m=8 kg and θ1=30 and θ2=60\theta_1=30\ {\rm and}\ \theta_2=60θ1=30 and θ2=60,
Find the acceleration of the system.